Interested to Buy Any Domain ? << Click Here >> for more details...
Hi How can you start-up the 40w tube lite with 230v AC/DC
without using any choke/Coil.
- 5 Answers
- 13306 Views
- I also Faced
- E-Mail Answers
Answer Posted / prakash
no
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What are test signals and their significance?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
If VFD is On but no starting commond on it. so how many outpout voltages of VFD
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you
What are the different types of dams?
How to calculate the fuel consumption for 600kva DG genset which connecting with 25%load?
What do you mean by turns ratio of instrument transformer?
what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?
how you taken aotitude test
Lt motor sfu flashing reasons?
Please provided formula for calculate the cable size from step up transformer to M.V panel, run overhead aluminum cables, total load is 5mega watt, total length 900 feet.
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
What is the formula to calculate the rating of power cable for three phase current.
