Three phase alternators are connected in star connection
why?
- 13 Answers
- 39066 Views
- Tanfac, I also Faced
- E-Mail Answers
Answer Posted / ashna & anju
in star conection ,phase voltage is lesser than line
voltage and induced emf in the phase winding of an
alternator is directly propotional to number of turns,a
star connected alternator will require less number of turns
than a delta connected one for the same line voltage.
| Is This Answer Correct ? | 68 Yes | 10 No |
Post New Answer View All Answers
what is the minimum clearance between a 11KV 150KVAR capacitor cell and series reactor.can a series reactor can be mounted in the same structure of the capacitor cells structure
What is power factor why we should maintain the power factor unless what will happen
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
what is static frequency converter?what is the function...of sfc...?
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
Dear All we are having a problem in G120 BOP showing alarm A0503, F0052, F0060 we can not remove fault alarm ,Please any body help us. kowsar
what is the write prosidure of stringing of 8meter pcc pole.
HOE WE CAN IMPROOVE BY USE OF CAPACITOR
How do we calculate over and under frequency tolerance from generator data?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
How can we measure earthing resistance test (Earth meggar) of Transformer neutral pit while in live condition?.
what is mean by descripiency relay? & wht is its ansi code?
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
How do you determine the size of transformer radiators in a transformer?
