sir please tel me how calucalte kwh if home taken load
30ams how maney kwh taken per day.and 3phase motor 5hp per
hars how maney load teken and how mach kwh and forward me
to electrical table for calicalte kwh and kvr and kvah
- 1 Answers
- 3284 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
By employing energy meter with required features.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is a types of short circuit and what is a types of distance protection tests
What is the capacity of the Fastners 12mm?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
power transmission pole used one support , that only for support or earthing
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
A ii kv 1200 A Breaker combination fixed in a cubicle. How many ampere Fuse is required? If fuse is not using, Why?
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
What is the formula to calculate the no load current of a single & three phase induction motor
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
what is POTT and PUTT explain?
what is meant by twilight switches 7 where its applicable ?
Difference between Lugs and Thimbles
