What should be the earth pit resistance value?
Answer Posted / ramkumar
Earth pit resistance must be less than 1 ohm then only we
have to get good earthing
Is This Answer Correct ? | 44 Yes | 4 No |
Post New Answer View All Answers
How to run a three phase motor into single phase........
how mass curve differs from hydrograph.
What are the advantages and disadvantages of closed-loop control system?
What is the actual meaning of thermal power efficiency ?
how you configure motorvision relay (L&T make)from DCS
What is rotary phase converter?
i am trying to PSUs/govermeant jobs since last 2 years but still i m not success, plz help me.
defination of transistor controlled series capacitor
when will be the iocl interview results ifaced the interview on september 8 th
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
i am electrical and elctronics engg passed out in 2009 want to attend for reliance placements.plz send me apttitude ,technical and hr question answers to my mail plz. my mail id-kat.bindas@gmail.com
by using pump duty, how we will can calculate the motor duty(KW)? is there any standard or formula.
What it the purpose of parallel phasing transfomers??
Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?
Mention the disadvantages of low power factor? How can it be improved?