in our transmisison sub station why we step down firstly
132kv\33kv then 33kv to 11kv. can we direct step down 132kv
to 11kv.
Answer Posted / manish
Yes you can directly stapdown 132 kv to 11 kv but in
general cases our transimision outgoing feeder may be
66kv,33kv or 11kv thats why we stap down 132/33/11kv ,if 33
kv not required then we can direct stapdown 132kv to 11kv
Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
what is the role and fuction of automatic transfer switch in rotary ups
Can you tell me more about pu systems (per unit systems )calculation in large power systems? how to get the base for voltage and power in generator, transformator and transmission lines?
how power is generated,and transmitted to our home..pls explain briefly in simple words.
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
What is maximum power transfer theorem?
What are the specifications for conducting earth leakage test as per IEC standard?
Why field rheostat is kept in minimum position while armature rheostat at maximum position?
which cable is used for 15 Hp monoblock pump 3phase and service wire Distance is 210 feet please tell me cable size Armaured
can someone explain that how the speed of the protection system affects the fault level calculation?
What is slip in an induction motor?
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
can mini-curcuit supply MIL-tested transformer !