Interested to Buy Any Domain ? << Click Here >> for more details...
I BOUGHT A HAVELLS ACCL WITH GENERATOR STOP FASCILITY(i.e-
BASICALLY IT IS A AUTO CHANGE OVER SWITCH) FOR MY HONDA EXK
2000S HOME GENERATOR (WHICH START IN PETROL & RUN IN
KEROSENE). ACCL HAS 8 POINT. 2 FOR MAINS(PH & NUE), 2 FOR
LOAD, 2 FOR GEN AND 2 FOR IGNITION POINT(X1 & X2). THE
IGNITION POINT IS SPECIALLY FOR AUTO ENGINE STOP WHEN MAINS
POWER RESTORE. I CONNECT THIS X1 & X2 POINT TO THE
GENERATOR STATER MOTOR & EARTHING POINT. BUT WHEN MAINS
FAILS THE GENERATOR COULD NOT START, BUT WHEN DISCONNECT
THOSE X1 OR X2 POINT, THEN THE GENERATOR START. BUT WHEN
MAINS ON THEN THE GENERATOR SHOULD START, AND WHEN I OFF
THE MAINS THE GENERATOR AUTOMATICALLY STOP.
PLESE HELP ME HOW I STOP THE GENERATOR AUTOMATICALLY WHEN
THE MAINS RESTORE.
- 2 Answers
- 11599 Views
- Honda, I also Faced
- E-Mail Answers
Answer Posted / finas
better you dismantil the accl and connect it directly.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What type of DC motor would you see for a lift?
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
how to measure dc earth leakage current?
Main advantage of auto transformer over two windings transformer is that A it needs no cooling B it uses only one winding C core losses are reduced D it has simple construction
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
what is p.s impedance measurement test in earthing transformer?
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
How much of the total hydro power potential has been exploited so far in india?
Mention the difference between Analogue and Digital circuit?
What should be the protection scheme for a 15kw, 3-phase motor working in a lathe machine.
Why two phase welding machine is used instead of three phase welding machine.
what is 400kv doble circuit quadpole tower?
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
What is the meaning of HT Trivector Meter ?
what is the difference between megger and earth resister ??
