Identify the keystroke used to terminate the setup mode?
A.) Ctrl-K
B.) Crtl-C
C.) Ctrl-Z
D.) Crtl-End
Answer Posted / vinayybx
the answer is B
in setup mode we use ctrl+c keys to terminate the setup
so the answer is B
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Tell us the name of algorithm of eigrp protocol?
What is cam?
What is 10base5 ethernet lans?
In IPSec what is SAD, SPD and SA's?
which algorithm as defined by the transform set is used for providing data confidentiality when connected to tyre?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
How we can see mac address from dos prompt?
Which protocol switch use for filling its mac-table?
Which mathematically form used inipv6?
What cable called v.35?
What does routing mean?
When ospf protocol advertise its routing table?
Tell me which cable called roll-over?
what command you must use if you want to delete or remove the configuration data that is stored in the NVRAM?
What is difference between tcp/ip and osi model?