Interested to Buy Any Domain ? << Click Here >> for more details...
Wht is Dry Leg Calibration and Wet Leg Calibration?
- 2 Answers
- 35833 Views
- I also Faced
- E-Mail Answers
Answer Posted / spencer
Dry leg is where the low pressure side is vented to ATM.,
and the vessel is open to ATM. Wet leg is where the vessel
is closed and the low side is connectd to the top bridle.
With each type the "legs" wil be filled with an inert fluid
with a higher density then the fluid in th evessel all has
to be taken into consideration when calibrating
instruments. I can normally hit a percent error of 1
%. Hope this helped the guy has no idea what he is talking
about.
| Is This Answer Correct ? | 15 Yes | 19 No |
Post New Answer View All Answers
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
What is sensitivity in vibration probes..?
Draw block digram for well head from well to shipping pump?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
what are the selections available in configuring a burnout protection of a controller? thanks
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
What is 3 element control system
how to commission furnace ( water heater)
why we are not using the turbine flow meter in the steam service?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
How to find out the current of two motors having same power consumption but different RPM?
Draw bode plot of any transfer function. Why is plotting bode necessary?
send me last 5 years questions asked in rrb chennai, for section engineer
how many type conductivity sensor ?
