Answer Posted / k. devendran
Normalley as per cummins generator commpaney recomanded
injecter checking, and valve clearence,flywheel bold
retorqch ,crankshaft end play, fan belt, fan hub bearings,
idler pulley bearings cheaking and grease refilling,
includind B' cheak [oil and filtters changing] theese are
C & D cheak
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
What are the advantages of a three-phase system over a single-phase system?
What are n circles?
All tape of electrical questions Answers tape of motor transformer e.o.t crane
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
What is proportional controller?
Explain in details how you would react to an unexpected incident when your supervisor or manager is not around to give instructions?
Explain the working of any one cutting machine
how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters
While testing LA mast,What are the parameter limits ?
Define conversion efficiency of a power amplifier.
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
Explain mechanical rotational system?
What is the cut-off rate?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
Why use the vcb at high transmission system ? Why can’t use acb?
