Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen when square wave is fed into input side of
3kva transformer and what you will get on output side.
- 3 Answers
- 6745 Views
- Blue Star, I also Faced
- E-Mail Answers
Answer Posted / soni
as e=d(phi)/dt(time)....so the output will be zero..and no
voltage as output will be dre..
| Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
why don't we use the generator as a motor? and what will happen?
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
If more than rated DC voltage appears across trip coil of the breaker, what will happen? e.g. in 110V DC circuit system, if voltage across battery terminal showing 121 V
how to find the Motor,s insulation Power?
What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
In a single how much maximum current and watts using
What is pole of the system?
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
How to calculate the fuse rating depend upon the DC circuit?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
will there be any problem by recovering slip from single phase induction motors?
