Interested to Buy Any Domain ? << Click Here >> for more details...
What should be the earthing resistance of an industrial
substation and also What should be the house hold earthing
resistance?
- 20 Answers
- 111939 Views
- Jindal, Pharma, TAAT, TATA, I also Faced
- E-Mail Answers
Answer Posted / krishna naik
The earthing resistance of an industrial substation
should maintain always below 1 ohm. it measured of
resistance between earth plae and natural earth by ohm
meter. when earth resistance is near to zero means better
earthing.
The household earthing resistance somewhat slight above
1 ohm and below 2 ohm is the tollerable limit, but never
neglect above 2 ohm. the resistance below 1 ohm means more
safety.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
wat is d diffr btw shunt coil and trip coil in VCB?
PLEASE INFORM ABOUT THE IDEAL TEST RESULTS OF MAGNETIC BALANCE TEST OF TRANSFORMER 33/11 kv DELTA-STAR T/F
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
what is the series parallel connection of capacitors? and how can we use these application in three phase motors for controlling torque?
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
how dose servo motor works
Can we put 3 layers of cable tray while installing tray
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
i have some screw comprressor with 630kw power,i have established them with simple star to delta circuit,by the way there is so much inertia when the screw comprressors start, can you offer me contactors power with 400vac or any cataluge to choose the contactors
can u please mail me the syllabus for GET exam for damodar valley corporation?
why swityard is necessrry requirement in any bis power distributin systems?
how to synchronize 3 phase slip ring induction motors of different ratings.
What are the weight of 800KV DA,DB and DC type tower ?
what is distribution board?
What are dependent sources?
