I am working in a process industry, in that there are
several sections devided in the SCADA screens and
individual sections may START independently. But sometimes
i am facing problem i.e, if section 2 Stopped by the
operator immediately Section 1 or Section 3 or Section 4 is
getting stopped can you expain the reason behind this?
- 5 Answers
- 4661 Views
- I also Faced
- E-Mail Answers
Answer Posted / chandramauli sinha
There r various possibilities:
1. Its a common stop for all sections and are linked at
single command from SCADA screen.
2. Variable of section-1 is linked directly or indirectly
by process/ logic/ variable to other sections. On stopping
of Section-1, the process/logic of other section is
recognizing as fault and stops the respective sections.
please check that is there any link between these
sections...!
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is dc moter.
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
what is the difference between Cv and air consumption? why the customer needs Air consumption details?
how to calibrate steam control valve in steam turbine
Draw bode plot of any transfer function. Why is plotting bode necessary?
Pl send the model question paper of mahagenco account officer post
What is hp & mp seperator .& what is its working principle ?
Explain Gas Turbine startup and shutdown sequences
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
how to measure oxygen which methods are using?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
What are de-saturators?
How d.p. Transmitter can be applied to close tank?
Explain pH, Conductivity.
Define cryogenic?
