Interested to Buy Any Domain ? << Click Here >> for more details...
What do you mean by Transformer?
- 9 Answers
- 16292 Views
- Hyundai, NTPC, wbsedcl, I also Faced
- E-Mail Answers
Answer Posted / vvreddy
Traansformer works on the principle of Mutual Inductance..
Tansformer is used to Step down or step up the Voltage level
as required for the need of meeting desirable voltage..
We can say its a static device which is used for the purpose
of distribution of voltage to the customers..
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
What are approaches to tackle sedimentation problem of reservoir?
How is the gain affected by the introduction of feedback in a control system.
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
WHAT IS THE FUNCTION OF SHORT CIRCUIT MAINTENANCE CT
Single line diagram for dbb (double bus bar)system.
Why do we need interlocking in a HT metering or Ring main unit switchgear?
what is the minimum winding resistance of 30hp compressor, to run or to switch on
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
best manufacturer for busbar for outdoor switchyard having double bus bar scheme, can any one share technical specification of busbar. 132kv voltage ?
What is diversity factor in electric installations?
what is meant by vector group of a transformer? How can it be derived?
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
what is mean by transition resistance of transformer?
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
