Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sudhir patil
By given load calculate the max. current & use standrad
gage table or normally 1SQ.MM For 1.5A Current.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
what are factors to be consider to design a HT & LT motor?
what is the voltage rating of chiller unit sensors
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
What is the important precuations need tocarried out while working with Electrolite in Battery PM?
In a flange coupling, the flange bolts are designed for
Which device is used for the source of emission of electrons in a crt?
Importance of fault current in power transformers and how to monitor the same? How is it different from winding temperature?
What is the most important precaution in any experiment with d.c. Shunt motor?
Explain in brief description about the operation of DG sets.
what does a k rating in a transformer means?
Why is the frequency not changed during transformation of electrical energy in a transformer?
How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?
electrical
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
What is the difference between cylindrical-type and sandwich-type winding?
