how i chosse capacitor bank if my energy meter is 48 kvr?
tell me capacitor bank chossen formula?
- 1 Answers
- 6030 Views
- ACC, Bhel, I also Faced
- E-Mail Answers
Answer Posted / siva24381
Fist you tell me what type of load connected(KW or HP) in
the system.
| Is This Answer Correct ? | 13 Yes | 7 No |
Post New Answer View All Answers
what are the installation procedure of high voltage power transformer,CT,CB&PT?
Difference between transition and diffusion capacitance
What it the purpose of parallel phasing transfomers??
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
How delta connection in the primary of distribution transformer reduces harmonics?how delta connections reduces harmonics?Please answer me...Hope that question is correct.
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
33kv Rated output avilable in market (any where in india)
what is the minimum pay scale for electrical engineer (building construction)in kuwait? plz revert back with yrs of experience & pay scale respectively.
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
What is the resonant peak?
How can get elongation of 2 k.G aluminium, if elongated aluminium dia is 2.5 mm?
Different types of relay fault which phase sequence??
