Interested to Buy Any Domain ? << Click Here >> for more details...
Suppose you have hot fluid and cold water, what fluid you
should flow in shell side and tube side in a shell and tube
heat exchanger and why
- 6 Answers
- 12138 Views
- I also Faced
- E-Mail Answers
Answer Posted / sagar mashru
Hot oil should be passed from tube side to prevent the heat
loss and it is desirable from safety point of view.
| Is This Answer Correct ? | 14 Yes | 6 No |
Post New Answer View All Answers
testing formula for oxygen by ammonium chloride,ammonium hydroxide and copper
why screw compressor use for ammonia compression?
Define a barometric condenser?
What are some factors to consider when trying choosing between a dry screw compressor and an oil-flooded screw compressor?
Explain the use of gear pumps in motor?
What is the method involved in analyzing powders for composition?
Where barrel pump use?
What are the reasons of removal of particles from effluent gas?
hi sir/madam i need placement paper of last years of DRDO in chemical sream...... send me the question paper as soon as possible on my email address praveen.zone@gmail.com
hi can anyone tell me some technical questions asked in iocl
What types of metals are typically removed via chemical precipitation?
What type of heat exchangers are most commonly used for a large-scale plant-cooling loop using seawater as the utility?
What is a good method of analyzing powders for composition?
Which type of pneumatic control valve is used mostly Either Air to Open r Air to close the value And guys I need reason for your reason
MY generator water cooler inlet line height - 11 mtr inlet water line height - 7 mtr water come into the line from overhead tank, O/H tank height - 20 mtr the first tapping in the inlet line is 2" line which down to 4 mtr level plateform., second tapping in inlet water line goes to a pump 6" line installed at 4 mtr level plateform, pump capacity 200m3/hr, head- 30 mtr, hp-40. the outlet of pump of 6" water line connected to a header of 6 mtr long of 6" line, on this header the six tapping are connected, 4 nos. 3" line goes to 11 mtr height water cooler the pressure of the line is 0.15 to 0.25 kg/cm2, 2" and 4" pipe line connected to a cooler at 4 mtrlevel plateform. my question is, at 11 mtr height level the quantity of water and flow is not sufficient for my cooler, the temp. of cooler is rises much more. you are requested to suggest the modification of pipe line/ pump for take more water flow and pressure (desired pressure is 1 kg/cm2)
