why the cutoff frequency is taken for 3dB and not other
values like 1 or 2 db???
- 3 Answers
- 5590 Views
- I also Faced
- E-Mail Answers
Answer Posted / syncopator
The 3dB point is useful because it is the point at which
power is one half of the value within the passband of the
device being considered.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Is it possible to isolate a drive by installing a offline ups and also drive should be protected during normal power supply availability and is the use of isolation transformer necessary.
Explain the difference between silicon controlled switch (scs) and gate turn-off switch (gto)?
what is bts ,what is e1 what is fifa card ,what is rri ,what is e1t1
Why do ics need small power for their operation?
How is the keycode calculated while interfacing a keyboard with a microprocessor?
What do you understand by collector reverse saturation? In which configuration does it have a greater value?
respected sir, I am Diptiranjan swain have already applied as IFFCO GET ONLINE FORM-2013.kindly,send me one set of previous year question paper.
Tell me why the shape of op-amp is triangular not other shape?
Explain what are the universal logic gates?
how does a soft starter works
how to write test cases?
i need to get a project idea on msp430 microcontroller can anyone help me
What are the different parameters that can be measured using a q-meter?
Explain how the active power factor correction changes the wave shape of current drawn by a load to improve the power factor?
I am electronics and communication engineer.i have applied for jr.executive at airport authority of india..plz recommend me any book on AAI and plz forward me last year question paper and interview question..i"ll be highly obliged...my email id is divya1220@gmail.com.
