what is skin effect? why is it absentin dc system
Answer Posted / shiny
The tendency of the AC current to concentrate along the
surface of the conductor is called skin effect.
The apparant resistance of AC is always higher than
DC .The alternating magnetic flux created by an ac current
interact with the conductor , generating a back emf which
tend to reduce the current in the conductor . The center
portion of the conductor is affected by the greatest
number of lines of force.The electromotive force produce in
this way by self inductance varies both in magnitude and
phase througr the cross section of the conductor, being
larger towards the centre and smaller towards the outer .so
the flow of current is maximum in the outer surface of the
conductor ,called as skin effect
In dC there is no inductance an dno skin effect.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
how to increase senstivity of ct
how can calculation ate Amps for cabel. Ex-for 1sqmm wire hou many amps we can draw
Leakage current,un balance current which relay using for high voltage transmission?
what is the main parts of transformer? how it is functioning? pls giv the ans briefly.
sir i had plane to do some project with the base of hopkinson test in AC supply its possible
why the rotor current becomes in steady state during high slip region? please verify with equations.
Pleae send me last 5 years of Question book about RRB chennai.
A power transformer 4MVA/11KV/0.415Kv has been out of use in 12years. what maintenance actions/test need to be carried out before energizing.
How much load can take a 16 mm aluminum cable 3 phase
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
plz tel me syllabus and exam date 4 jr executive engg (electrical)
WHAT IS DOL STARTER? HOW IT WORK? GIVE ITS CONTROL AND POWER DIAGRAM .
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
ht side line to earth voltage
What is d main advantage of using double circuit 3 phase transmission ?