Answer Posted / fahad
bcoz the power factor of load is not known during the
manufacturing, this is also done during load calculation.
For reference you can see a indian book " B.L Theraja -
Electrical Technology" ....
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
what is the difference between skin effect
describe the phenomena of vacuum interruption in C.B
can u give me a brief idea about power line carrier communication ??
Explain forward resistance, static resistance and dynamic resistance of a pn junction diode.
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
What is the equivalent circuit of a transformer and its vector diagram?
What is dc current source? Differentiate between ideal and non ideal current sources?
As an electrical engineer what are the responsibilities which i can hold in TCS?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
what is Fault level? why it is calculated? how will u decide same for our plant?
what is meant by rotating magnetic filed
For a stable system, where should the poles of a system be in a root loci plot?
please send privious years question papers of jindal steel and power ltd.My e mail id is rajanikant.sngh@gmail.com
why ht cable end termination don't have a gland?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
