how to rectify the problem ,if we erected the DPT instrument
wrongly of hp on lp side and lp on hp side?
- 5 Answers
- 7705 Views
- I also Faced
- E-Mail Answers
Answer Posted / komal
1)Remove and re install correctly
2)Change calibration range if presently set as 0 to 1000
mmH2O to 1000 to 0 mmH20 and make required changes in
control system to see it correct.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
If P will increase then what will happen with PID?
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
How to calibration coriolis flow meter?
What is 1:1 redundancy ?
What are the interlocks we have to check during the start up of LP/HP compressor?
how to calibrate Necleuonic level transmitter.?
Explain bernoulli’s theorem. State its application.
key exchanges in wpa,wpa2,tls
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
How to Calibrate Ultrasonic Level Transmitter in field
how do u calibrate the vacuum transmitter if it shows more reading
How u measure the massflow in orifice flow measurement techniques
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
How an rtd work, and what volts/current goes to a rtd to measure the resistance?
