How to take Vector group test of Transformer?
Answer Posted / vinay kumar
can anybody tell hw u r writing this is the vector group
calculation for this one.....
what happens if the voltages r not satisfied for the
specified vector group and if so what to do.......
Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
What is the formuala to calculate the rating of motor protection circuit breaker
What is expention fastener (Fan)
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
Y phase plates are used in transmission line??? what is there need???
Can RCD's used to protect the VVVF drive if not why.
how to calculate percentage impedence at 75 deg C at normal tap
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
iam working in power plant. In hot places tube lights are glowing at the end portion only. what is the reason for that?
WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?
whats the application of voltage regulation? and whats the voltage regulation's device?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?