how to calculate earth resistat in earthpit with earth
testing kit?
Answer Posted / thanigaivel
In that earth tester E1 and P1 short with wire and take a lead from that loop. and put 2 spike in that mother earth 1st spike connected to E2 and p2 connected to that another spike ... that looped wire is connected to earth bit . and put the earth test with ohms .. its show the value
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
advantages & disadvantages of Lagging and leading power factor .
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
State Maximum Power Transfer theorem.
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
What is mean by hot and cold loop testing?
1.why we are using blocks in withoutgaplightning arrester 2.why we ar using bushing in withoutgap lightning arrestor
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
What is a system?
Why we are going for converter transformers for DC drives application instead of distribution transformer?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
Why to keep capacitor bank off while generator running.
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
Difference between low impedance and high impedance Restricted Earth Fault