Interested to Buy Any Domain ? << Click Here >> for more details...
HI FRIENDS IHAVE QUESTION 1.WHAT IS PARTIALSTROKE TEST?WHY
IT IS USED ON ESD ON OFF VALVES?
- 3 Answers
- 8624 Views
- KNPC, Rotork, I also Faced
- E-Mail Answers
Answer Posted / syed abdul mateen
ESD's are checked anually by applying partial signal from
DCS to ESD's.They are made to open partial and checked.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
How d.p. Transmitter can be applied to close tank?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
what is the reason while warning lamp is on while the engine is cranking?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
Any body have know try work calculation ???
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
what is vibration a part of proceess variable? if vibration is a part variables then how we minimize the actual vibration on machine on load,? vision of instrumentation contrl plz ans me IPGDL interview question
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
What is the use of double seated valve?
