Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between potential Transformers and
capacitive voltage transfoemers and where it is used?
- 5 Answers
- 13377 Views
- I also Faced
- E-Mail Answers
Answer Posted / ajay vikrant
The purpose of VT and CVT in EHV system is same ie. to step
down the EHV to low voltage for measurement and protection
purpose. The extra function which CVT performs is to trap
the high voltage signals from the line which are used for
PLCC communication.
Capacitance also reduces breaker TRV and steepness
overvoltage on the system.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
dear all i am kumara now current working in electrical designing of control and relay panel i want learn some substaion design then any book are available. pls mention name and authour
what are pilot cells
how tto ingress mw in turbine explain.procedure ?
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
Why collecting electrode of ESP to be earthed
What is tan delta & PPM in transformer? and whats its IS value?
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
What are the special cables required for explosion proof wiring?
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
In CTs tan delta point should be earthed , what is the reason behind it?
