Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / whiteax
A sensor containing a processing device that performs spontaneous digital signal processing and conditioning when it receives multiplexed sensor inputs is called a Smart Sensor. When this input, after processing, algorithmic decision-making and actuating, becomes an output signal, the smart sensor behaves as a transmitter. This dual-function is why it is called a smart sensor/transmitter.
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is loop1 and loop2 in MTS LT?
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
steps for installing orifice plate?
how to check earthing,what is minum ohms for proper earthing
Describe a time when you anticipated potential problems and developed preventive measures.
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
if my flow is 20000 m3/h than which range of DPT i have to use????
which processor is used in dcs.
what are the selections available in configuring a burnout protection of a controller? thanks
How to convert Differential pressure to flow in TPH
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
Difference between ultra sonic flow meter
selection of the zener barrier for the hazardeous area zone 0
why would you like to join our company
