Interested to Buy Any Domain ? << Click Here >> for more details...
Why HT voltages are expressed in 11KV,22KV,33KV and so on? (ie
in times of 11)
- 3 Answers
- 10181 Views
- Bhel, Park Hotel, I also Faced
- E-Mail Answers
Answer Posted / meenakshi
every1 say the reason is form factor 1.1....but the actual
reason is,according to the international stds, for every
100V, 10% of voltage is added for the compensation of
transmission loss.
| Is This Answer Correct ? | 10 Yes | 4 No |
Post New Answer View All Answers
What is the safety of UPS?
why the field winding in dc motor is not short circuited eventhough dc supply is applied across the winding
WHAT IS DEAD END IN PROTECTION?
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
When we need up only in o/p 440v, so why we use directly in 11kva in input?
while starting a liquid starter ,is there any volage drop on water/soda on tank.can we touch the tank on starting?
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
in what type of applications v can use q meter?
if i am in front of transmission line how to know that current direction without any equipment
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
can we install HT panel & LT panel side by side or how much clearance is required ?
