In any Industry, Which voltage level either 3.3kV or 6.6KV
to be chosen? Then I would like to know ,Is there any cost
consideration or Rating of motor?
- 5 Answers
- 9371 Views
- I also Faced
- E-Mail Answers
Answer Posted / veena
To choose the voltage level for any Load two factors has to
be considered one is the Total load and the distance of
transmission line .There is a formula to calculate the
economic transmission voltage
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
i have a 1500kVA transformer what is the kWH meter i need to use?
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
What is the difference between rulling span and wind span of of an Over Head Transmission Line?
Operation carried out in thermal power stations?
Write down the design procedure of commutaj.
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
can we find the inductance of a induction motor?
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend
what is the acceptable limit value for Desolve Gas Analysis/
I am EEE student i want to improve my core side skills.how cn i approach it?
Explain about retrofitting of machine tool.
Why using synchronising methed in DG's sets?
