how to check IR values in alternator winding?
Answer Posted / k.prakashchandra
Isolate all phase windings at both ends and measure IR of
each phase to body and between windings
Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
what are the pecularity of shaver sockets ?
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
What is mean by hot and cold loop testing? What is the difference between them?
How to calculate flow of water delivered by pump when pressure & size of pipe line is given
what is rating boiler
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
What is vaccum currcuit breaker.define with cause and where be use it device?
What is sink and source?
Hello to all, Please someone can send me HPCL ELECTRICAL Engg. Sample papers to me? Its urjent....my email address is.... raviasiapacific@gmail.com
What is different between Difnit time and instatous over current relay
The Howland current source produces a A Unidirectional floating load current B Bidirectional single-ended load current C Unidirectional single-ended load current D Bidirectional floating load current
what is the difference between transformer,converter and transducer
what is the relative size of single and three phase?
Air refrigeration cycle works on the
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors