Interested to Buy Any Domain ? << Click Here >> for more details...
What are the difference between C-Curve and D-Curve for
MCB's.
- 17 Answers
- 192304 Views
- ABB, DLF, Essar, GK companies, Nissi Engineering Solution, I also Faced
- E-Mail Answers
Answer Posted / venkatesh s.r
"C" curve is used only for lighting because of Starting &
runnig current is same in that circuits
"D" curve is used in electronis circuit like
computer.Because of it will be with stand high armonics &
initial rash current.
| Is This Answer Correct ? | 8 Yes | 79 No |
Post New Answer View All Answers
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
How to setting the volume of RTCC panel AVR (11kv) controller
how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
I want to know all basics of electrical engineering
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
What is a dominant pole?
briefly explain the main blocks found in a microprocessor based system
Explain the working of any one cutting machine
how to calculate slip ring induction motor stator and rotor currents??
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
State the points to be considered for selecting a particular type wiring.
