Interested to Buy Any Domain ? << Click Here >> for more details...
formula for cable size calculation for current?
- 10 Answers
- 43065 Views
- KL Power, ONGC, RL Clean Power Pvt Ltd RLCPPL, SAS, Sobha Developers, I also Faced
- E-Mail Answers
Answer Posted / fathi
2x10 sqmm Cu/XLPE/PVC 600/1000 v
| Is This Answer Correct ? | 17 Yes | 16 No |
Post New Answer View All Answers
distribution is maximum done by a)radial b)network c) parallel d)b & c
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
How could I get a certificate of competency as Electrical Supervisor? I have completed By BTech in Electrical this year(2012) for VJTI Mumbai Maharashtra. Is it compulsory to be produced while joining?
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
how we calculate the withstansing current capacity of wires&cables?
how to deside the capacity of chock for drive?
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
Why hydropower stations are preferred solution for meeting peak loads in grids?
what is the preventive maintence for ht panels and busbars and vcb abd acb's.
How many types of faults are there in 3 phase power system?
why single phase to grd test in HV cable?why not 2 phase at a time?
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
what r the checklist while installing a 380 kva DG set
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
