Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / r.dharma
normally we want generate the voltage should have conistant
poles so that reson we have to give excitation i.e d.c
supply to the generator.
| Is This Answer Correct ? | 5 Yes | 11 No |
Post New Answer View All Answers
how to select the isolation tranformer for siemens 802dsl cnotroller
why d.c produces corrosion
Pl.brief me any electrical major fault you have rectified.
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
why power not passes in plastic and rubber material
how to find the multiplication factor for digital energy meter and analog energy meter
What is the bundle conductor?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
WHAT IS VCB SAFETY
Please brief me about number of pole in alternator.In single phase alternator coils are connected in star or series. How to calculate frequency for the same.
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
how calculate gd2 of ht motors
What is Negative Potential Bias
