WHY EXCITATION OF SYNCHRONOUS MACHINE IS DC NOT AC
- 8 Answers
- 14114 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / lokesh
We need a statoinary magnetic flux in synchronous machine,
this flux will be cut by the rotor.
| Is This Answer Correct ? | 7 Yes | 7 No |
Post New Answer View All Answers
State the points to be considered for selecting a particular type wiring.
How to Prepare preventive maintenance shedule of machine tool.
What are the advantages of stationary armature and rotating field system?
what is inter connected dc generator?
Brief working principle of stabilizer,application & safety precautions
how many joints are allowed in underground HT cable of 1 KM
Why power genaration in India is at 50HZ while America its 60HZ
What is the disadvantage in proportional controller?
what is self capacitance of inductor
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
what is the write prosidure of stringing of 8meter pcc pole.
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
What is the resonant peak?
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
