Interested to Buy Any Domain ? << Click Here >> for more details...
Why is cover provided in beams, slabs, lintels, columns, etc ? What is the drawback of not providing cover in the same?
- 9 Answers
- 18700 Views
- I also Faced
- E-Mail Answers
Answer Posted / kosygin
what ever leave rusting and corrosion... water moisture..
cover r provided for better bonds with concrete..
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
If 40 backlogs are cleared m finally with 65 percent marks . Am I eligible to get visa to US
can u plz send me ntpc placement papers(civil engineering) at mohit_verma21@yahoo.com
a rectangle grill of length 72 inch x 20 inch width.how to calculate bar spacing ,bar consist 8 mm thickness and spacing of bar is 2 inch.. calculate no of bar with formula
I am a civil engineer . I am also selected for sbi clerk interview which is to be held on 4th May2010 is there anybody resembling the same? what question can be asked and what should be the probable answers?
How to calculate the cement plastering for circular and rectangular water storage tanks and how to calculate the area of circular and rectangular floor?? Please help me
In earth work 1300 cum soil how to calculate how many liters require in water
Civil engineering material testing Standard results
What is the number of IS code of practice to be followed for hydraulic design of sewerage pipe line?
What is Curtailing of R/F
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
What is dead load impact load live load
) Design a gussetted base for a column section consisting of one sc 250 with two cover plates 300 x 25 mm carrying an axial load of 2500 KN. The S.B.C. of soil is 250 KN/m2 and the permissible bearing pressure on concrete is 4000 KN.
I have a slab of 20cm thickness of 20m by 4m in wich we are installing 15 tons electric panels , and we have put 4 H-shaped columns under the slab but we have done many cores in the slab which seems very normal , can you help me by telling me how to calculate the bearing capacity of the slab or give me an idea if i should increase more columns Note: load distribution area 12*1.5 m2
What is the thickness of slab for 600 sq each) 2 slab construction. What should be the size of steel rod?
how to calculate the mortar for 10'*10' size room for both plastering and for masonry work?
