why microprocessors are named as 8085 ,8086 etc?
what's the reason for this???
- 15 Answers
- 40093 Views
- Bhel, HCL, I also Faced
- E-Mail Answers
Answer Posted / harshal
the first 80 is the specific series . nw,
it has 8 software interrupts and 5
hardware gh intrepts. thats y 85. i
think this will enhance your
knowledge !!
| Is This Answer Correct ? | 3 Yes | 14 No |
Post New Answer View All Answers
i need list of swg(standard wire guage) or area of conductor v/s current carrying capacity of conductor copper & alluminium...
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
can u describe the method used for protection of transmission line.
if a.c supply is given to the motor,, what happen?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
can anybody tell me that for p.f. Improvment we use capacitor banks but how to decide its capacitance. As we all know how to calculate kvar but what abt capacitance value
how to determine Sq.mm size of finolex power cables.
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
What is meant by celling voltage & current in excitor ?
What is the effect of positive feedback on stability of the system?
what is load vs Torque curve & why it is used?
I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????
In Indian Household, generally we receive 220V AC single phase supply. But AC has 2 phases, +ve & -ve. So in +ve half cycle current is flowing...so what happens in the -ve half cycle?? Please illustrate.
How to calculate fault level of 11 KV system
