Interested to Buy Any Domain ? << Click Here >> for more details...
My friend has
faced this
question! I
don't know
clearly. So
please anyone
give me the
correct and
short answer to
this question?
What is variable
frequency drive?
Types, what is
star to delta?
Why this
arrangement
necessary?
- 5 Answers
- 10234 Views
- Asian Paints, TCS, I also Faced
- E-Mail Answers
Answer Posted / vasu
VFD are used to make the motor to run in desired speed. By
variying the input supply frequency we can vary the speed of
the motor. some other types are VVFD - Variable voltage and
frequency drive, Vector drive.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
WHAT IS MEANT BY PROJECT MANAGEMENT STRATEGIES IN INSTRUMENTATION?
what is 24vdc live and dry supply
What is Predictive Maintenance
How to find out the current of two motors having same power consumption but different RPM?
Which type of pressure can be measured by primary elements?
What is cut off relay? And why use in PLC and DCS?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
which type of zones used for boiler? & why ?
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
what is actual drum level and compensated drum level?
What is loop1 and loop2 in MTS LT?
