how pressure reduce through pressure control valve? suppose
we have to reduce 20 kg pressure to 10 kg pressure , then
what we do ? open the valve or close the valve , initially
it is 20 % is upon ( for ur knowledge ).
- 4 Answers
- 6708 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / daxish_02
If pipe size is same before and after so this answer is correct..
basic fundamental behind the general formula that is
pressure=force/area......ok
here pipe size is fixed...ok
assume 20% valve open....than area of pipe cover after the valve is more so we get some pressure..
assume that valve open 40% so area of material flowing through valve increase so pressure decrease after the valve.....
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
how to relay switch sense the fault?
What are different types of control valves?
What is difference of fanuc alpha series 16i and 18i controller.also what is differnce betn TC and MC controller
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
what is easiest way to read STL language in PLC?
How many ohms are required for proper earthing?
What is offset in a control system.
What is stripper & spilitter ? Diffrence in this.?
What is super thermocoupal?
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
