Dear All, How can I make 5VDC with 500mA current rating
from our 230VAC. Can anybody help me with different answers?
I am Ansari-9820016777.
Answer Posted / shyam
yes as kumar said........use a step down transformer and use
a bridge rectifier at its output .and some filters before
giving it to a 7805 ic...take the output at 7805 .simple
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
Give the difference between transducer and transponder?
hi i am electronics & telecomm engg & appling 4 the AAI jr executive (electronics/ATC) written test. pls forward me the syllabus & old question papers.I will be very much thankful to you. pis inform to mpnisi@gmail.com
Difference between electronic and electrical.
Why are ics more reliable than discrete circuits?
can you give me example of igbt drive circuit... i still not under stand how it can be design with certain equation using mathlab program...
Why π-filters are not suitable for varying loads?
what are the components has to be done in fpga board (altera)?
In order to find out stack fault of a three input nand gate how many necessary input vectors are needed ?
Where is the maximum temperature in refrigeration cycle? a.Between evaporator & compressor. b.At Compressor c.Between compressor and condensor. d.At condensor
What are the advantages of gto over scr?
interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.
What are different categories of antenna?
Mention some of the applications of controlled rectifier?
How can I make calculation to Install level transmitter (DP) for open tank and close tank
What do you by interfacing in PC ?