Interested to Buy Any Domain ? << Click Here >> for more details...
what will be the motor terminal box connection arrangement
(star or delta). on what basis it decided?
- 3 Answers
- 9235 Views
- I also Faced
- E-Mail Answers
Answer Posted / raj.s
it depends on motor rating if it star typr connection will
made by shorting one terminal bed fully,
if it delta motor then accoding to diagram terminal
connections will occur in terminal box.
its just a connector ,we can made eithr star or delta.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
How many VSC based HVDC are there in India and the world
What is the difference between UPS & inverter ? which UPS is better and whos got the edge ? what is the difference between & inverter ? which UPS is better and whos got the edge 12 V , 24 V , 36 V etc what are the advantages of 12 V, 24 V , 36 V etc and what are the disadvantages of 12 V, 24 V, 36 V etc thanks
What is the cut-off rate?
How could a garment factory benefit from renewable energy
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
Why lose 1 phase voltage in 33kv to 415v stepdown transformer
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
How does a battary stores charge in it? please explain in simple manner and in detail.thanks
Can i use the B-curve MCB instead of C-curve MCB
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
