how pressure reduce through pressure control valve? suppose
we have to reduce 20 kg pressure to 10 kg pressure , then
what we do ? open the valve or close the valve , initially
it is 20 % is upon ( for ur knowledge ).
- 4 Answers
- 6709 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / g.s.arun
to open the byepass valve ,to reduce the pressure 20kg to 10 kg.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
the output of the common trasmitter protocol in qatar gas are the following
how u calibrate pneumatic n motorized c/v?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
What is the purpose of LO Overhead tank in turbines.
what is sil (safety integrity level
What is the use of gauge?
Operational amplifiers
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
What is motion balance principle?
how many type of plug are used in pneumatic control valve,name them.
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
wich is coming the first HAZOP OR SIL
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
