in our sub station why we step down firstly 33kv\11kv then
11kv to 430v. can we direct step down 33v to 430.v.
- 18 Answers
- 36533 Views
- Eaton, Siemens, I also Faced
- E-Mail Answers
Answer Posted / gurucharan singh
Yes 100% you can directly step down from 33KV to 0.430KV.
You must take care transformer sizing should be as per LV
switchgear available at your end.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
How does cost of generation from hydropower plant compare with other sources of electricity?
How many lightning arrestors to be installed on 50MX60MX10M building and is there any formular for that?
USE OF 8 WAY PAN ASSEMBLY
PLEASE ANYBODY HAVE ELECTRICAL CIRCUIT DIAGRAM FOR CHMER PULSE CD 60M SPARKING MACHINE.PLEASE MAIL ME SUPRIYAAYYAPPAN@YAHOO.CO.IN.
What are the advantages of skewing of cage rotor conductors?
What is MSL designation of a motor and same may be provided in details.
What current position are you holding in your current company?
Can anyone tell the proper diagram of star delta starter????
can we use engine degreaser for electrical motors?
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
how withstand of hi-pot test outputs of transformer wire 2.5mm
What is the different types of cable & current capacity of cable
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
