Interested to Buy Any Domain ? << Click Here >> for more details...
how much test voltage should applied for tan delta test.
- 2 Answers
- 5672 Views
- Electrical, TATA, I also Faced
- E-Mail Answers
Answer Posted / abhijeet
Generally tan delta test is taken on voltage level of 2
kV,5kV , 10 kV using test kits. but factories perform the
test on rated voltage level of that particular instrument.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
What is Harmonics how it is produced and what is the method to control the same
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
Can I use star delta connected induction motor for dual supply voltage?
How many types of losses occur in a transformer?
Direction of flow of active power and reactive power with logic?
area control error
Define gain margin?
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
can any one suggest paper presentation topies for electrical engg?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
In all analog voltmeters or ammeter showing some small size symbols. as well as a star and in star 2no. digit, resister symbol,and other. what is that's meaning ?
