Interested to Buy Any Domain ? << Click Here >> for more details...
What is C.T, why it is used and what care should be taken
for that while connecting?
- 20 Answers
- 29944 Views
- Bhushan Power Steel, I also Faced
- E-Mail Answers
Answer Posted / rajendran.m
C T is Current transformer.Current meassured in H.T side.
| Is This Answer Correct ? | 4 Yes | 7 No |
Post New Answer View All Answers
how to electrically make connection to ferroli GN2N?
What do you mean by ratio correction factor of instrument transformer?
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
what the principle of sincroscope?how it works?when it needed?
why ht motors are star connected?
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
Any one can explaination about calibration with rotating sub standards?
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
Why do we require transformer with less specific weight if supply frequency is increased?
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
power transmission pole used one support , that only for support or earthing
what is the working process of over & under voltage relay.
describe the fully control circuit diagram of ac drives
State the points to be considered for selecting a particular type wiring.
I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??
