Interested to Buy Any Domain ? << Click Here >> for more details...
difference between over current and over load protection?
- 5 Answers
- 14987 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / raji
IN AN ELECTRICAL CIRCUIT IF THE CURRENT EXCEEDS THE
SPECIFIED LEVEL(FULL LOAD CURRENT) IS CALLED OVER CURRENT.
TO PROTECT THE MOTOR OR ANY ELECTRICAL EQUIPMENT FROM OVER
LOAD(OVER LOAD CAUSES WINDINGS MAY BURN OUT OPEN ETC.,)SOME
CIRCUITS ARE PROVIDED TO PROTECT THE MOTOR THIS IS CALLED
OVER LOAD PROTECTION..eg., IN DOL STARTER OLR IS PROTECT
THE MOTOR FROM THE OVER LOAD
| Is This Answer Correct ? | 10 Yes | 7 No |
Post New Answer View All Answers
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
What is meaning of out of phase (making & breaking) capacity And how to calculate
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
what is the difference between directional & non directional earth fault with example please explain.
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
what is consequences of neutral and earth connect?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
What is an ac motor?
can anyone send me some sample question regarding power grid corp
IF DISTANCE IS 100METERS B/W AMP.METER AND CURRENT TRANSFORMER WHAT WILL BE AFFECT IN ACCURACY .METER CAN SHOWING ACCURATE CURRENT OR NOT IF NOT WHAT CAN I DO TO GET 100% ACCURACY.
1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.
What does the term power factor shows?
What is conventional thermal current (Ith)
does a DG set has low fault level as compared to that of a transformer.If yes then why.
