Interested to Buy Any Domain ? << Click Here >> for more details...
can any one explain me the where is the use of plc and scada
- 4 Answers
- 6476 Views
- I also Faced
- E-Mail Answers
Answer Posted / pprakashbabuachuta
PLC IS MOSTLY USED IN HY CRICTICAL FUNCATION
SCADA USED IN MONATRING THE OPERATION & OPERTION THE
LOGICAL OPERATION scada is connected with plc through pc
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
oltc of a transformer, how it works? and what are the equipment consist of describe briefly?
hello friends.. I have a doubt regarding the operation of dc machines.. I studied in a text book that a dc machine can be used as a generator and as a motor.. is this possible? If so,please send me the info about this topic.. you can also send your info to my mail.
what are inductive and capacitive voltage transformers.what are their applications
How does PLC work for sychronising of Two or more DG sets?
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
Why is better to have a minimum ceiling voltage of 250% than 160%?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.
can we do the star delta connection of capacitor for 3- phase motor starter.
in non technical way how can u define POWER FACTOR??
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
Should power factor be low or high?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
