Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ns
Calibration means minimizing the error compare with
standard test and calibration instument. According to the
manufacturer/user specified accuracy limit.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why mmwc unit is used?
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
why orfice is not used for main steam flow calculation
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
what will the sending unit in the fuel gauge utilizes?
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
Manipulation of dead wt. tester double piston type.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
i want to find out iffco get test paper
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
please send data bank of quetions answers on analytical instrumentation.
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
Why do you want to work here
