Interested to Buy Any Domain ? << Click Here >> for more details...
wats the procedure to calculate no of batteries for ups?
- 1 Answers
- 4790 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
When the ups voltage = battery voltage,Number of batteries
required = desired back up hours x load /V x AH of each battery
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the difference between neutral and earth
specify the inbuilt protections in DG
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
What is Instantaneous Earth fault relay,how will work
what is transient voltage?
Safety of on line ups
What are the essential characteristics of signal flow graphs?
What is Surge Capacitor? Why it is use in Generator Circuit Breaker?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
What does the term power factor shows?
What is the importance of earthing?
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
Draw transformer phasor diagram.(full load,no load)
What is a single phase autotransformer?
