What is working principle of washing machine?
Answer Posted / cmkashifabrar
Suppose I want to improve performance of my washing machine.
Ways I might do this fall into three categories:
1. Supply missing inputs. It needs water, soap, and
electricity. If any one of them is missing, I can greatly
improve performance by adding it — by plugging the machine
in, for example. These changes are easy because water, soap,
and electricity are easy to get.
2. Replace broken parts. This will also greatly improve
performance. These changes are very difficult unless I am a
washing machine repairman.
3. Everything else. To improve performance any other way
will be difficult and any improvements will be small. These
other methods of improvement — such as putting special disks
into the wash — are also likely to be dangerous.
| Is This Answer Correct ? | 19 Yes | 66 No |
Post New Answer View All Answers
What are the reasons for the parallel operation of transformers?
how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me
what is induction furnance? how many phase supply given io its coil for 15 or 20 ton furnance?
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
which is chemical used as in ro water what is difference betweeen multi grade filter&dual media filter
what is per unit calculation?looking for simple and strong explanation thk u
Why we use duplex coil and hook switch in telephone system?
What is meant by reverse polarity and how it can be fixed?
plz send me the syllabus or any sample paper for engineer trainee recruitment if any,on ravinder911@yahoo.com
what is the minimum winding resistance of 30hp compressor, to run or to switch on
What is relation between mu(nought) and epsilon(nought)?
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
Can an inverter be used as a converter? How?
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end