Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.prakashchandra
This relay is used for stator earth fault protection for
generators.The vector sum of three phases in all corners of
delta connected PT secondaries is zero.One of the corners is
taken through a voltage relay.Operation is as above.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
Whether it is possible to measure energy at the input of rectifier transformer (12 pulse with very high odd harmonics)
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
what is electrical machines
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
what is the solution for meger test failed the MV cable?
What are the advantages of instrument transformer?
What are the advantages of speed control using thyristor?
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
What happens if we connect a single phase energy meter in reverse polarity.
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
what is auto re-closer?
What are the causes for the failures of sandwich type (Al) busducts?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
