what is the power factor?please tell me uses.
- 5 Answers
- 6842 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / masoom raza
its cosine of angle between voltage and current of the given system.
its present in both ac and dc circuit but in case of dc its always 1 as angle between voltage and current in this case is always 0 degree.so generally we don't talk about pf in dc.
but in case of ac it varies from 0 to 1.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what does vector group Dyn11 tell us? also tell me how will u differentiate between phase lead and phase lag thru this vector group
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
What does the a,b,c of 95a,95b,95c relays denotes?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
What is the meaning of floating point earthing in battery backed systems ?
how is working bearing heater?
What is Instantaneous Earth fault relay,how will work
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
What is the actual meaning of thermal power efficiency ?
WHAT IS IM (INDEX OF MOUNTING )IN MOTORS
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what happen if the parallel generator phase angle shift by 1 degree in manual mode
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
