Answer Posted / rakesh kumar
well all the people who answered this please note that an
idmt relay is different from an inverse realy in the manner
that it shows the inverse operating behaviour only uptill
the pick up value is attained and after that it attains a
constant operating behaviour that is its operating time
becomes independent of the magnitude of the fault current .
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
difference between high and low impedance BUS BAR relay??
i am completed diploma in ece,and working in ht and lt lines.so is elligible diploma in ece for get electrical C Licence?plse give ur opinion?
What happens to voltage when current through the inductor is constant?
what happen ehen synchronisation is done at below rated speed
why and how current drawn by battery charger depends upon the altitude where it is located?
What is expention fastener (Fan)
Leakage current,un balance current which relay using for high voltage transmission?
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA
Is there any abbrevation for STUB in Stub bus protection
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
how to calculate vfd o/p voltage by frequency
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
what is the importance of Partial Dischage test for Electrical Equipments
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
how we calculate electrical load on a building according to area?